Electronics designed around your product, not the other way round
From a requirement on paper to a working prototype on the bench: architecture, schematics, component selection, power and I/O design, bring-up and testing.
Hardware Design, done properly
System architecture
We choose the processor, radios, sensors and power architecture that meet your cost, size and battery-life targets.
Schematic design
Clean, reviewed schematics with design notes, so anyone can understand and maintain the design later.
Component selection & sourcing
Parts chosen for availability in India, second sources and lifecycle — not just the datasheet.
Industrial interfaces
RS-485, 4–20 mA, 0–10 V, digital I/O and relay outputs, with the protection and isolation field wiring needs.
Power supply design
Wide-input DC, battery and solar-powered designs with efficient regulators and proper protection.
Prototype, bring-up & test
We build, power up and test the first boards, fix what we find and hand you a working prototype.
A clear process, with check-ins at every step
- 1
Requirements
What the product must do, where it will be used and what it may cost.
- 2
Architecture
Block diagram, key parts and power budget, agreed before detailed design.
- 3
Schematic
Detailed design with peer review and a costed BOM.
- 4
Prototype
Layout, fabrication and assembly of the first boards.
- 5
Bring-up
Power-up, testing and fixes, then a revision if needed.
What you get at the end
- Requirements and architecture document
- Reviewed schematics (PDF + native files)
- Costed bill of materials
- Working prototype boards
- Bring-up and test report
- Design files ready for PCB layout
Tools we work with
- Schematic capture
- Component selection & sourcing
- Power supply design
- Battery & low-power design
- Sensor interfacing
- RS-485 / Modbus I/O
- 4–20 mA & 0–10 V I/O
- Prototyping & bring-up
- Certification-ready design
Working with a different chip, toolchain or platform? Tell us — we adapt to your stack.
Where this service is used
Questions about hardware design
We only have an idea. Can you start from there?+
Yes. We start with a short requirements discussion, then propose an architecture and a costed plan before any detailed design work.
Can you redesign an existing board to reduce cost or replace obsolete parts?+
Yes. We review the existing design, suggest alternatives and redesign the affected sections while keeping it compatible where possible.
Do you help with certification?+
We design with EMC and safety requirements in mind and prepare the documentation test labs ask for. Testing itself is done at an accredited lab.
Often combined with
PCB Design & Layout
Multi-layer layouts with DFM checks and complete fabrication outputs.
Learn moreFirmware Development
Microcontroller firmware, drivers, RTOS, communication stacks and OTA.
Learn moreIndustrial IoT Solutions
Device-to-cloud systems with gateways, dashboards, alerts and reports.
Learn moreHave a product idea or a board that needs work?
Share your requirement, drawing or existing design. We'll reply with questions, a plan and an estimate.